5Test-Scanning Documents

Using ScandAll PRO, you can test-scan documents to check if they are scanned with the ADF correctly. For how to scan documents with the flatbed, refer to “Chapter 4 Various Documents” in the Operator’s Guide.

The following describes how to test-scan a document:1 Turn on the scanner.1)Press the “I” side of the main power switch of the scanner.2)Press the [Power] button on the Operator Panel.

The scanner is turned ON, and the Power LED on the Operator Panel lights in green.

Note that while the scanner is being initialized, the indication of the Function Number Display changes as; "8" D "P" D "1", where "1" means that the Operator Panel is in the Ready Status.

If you see an error indication other than the above on the Function Number Display, refer to “Chapter 7 Troubleshooting” in the Operator’s Guide.

Ex. :If “U” is displayed on the Function Number Display, it means that the Transport Lock remains locked. In such case, you need to unlock the Transport Lock.

For how to unlock the Transport Lock, refer to “Section 2 Installing the Scanner” (on page 13).

ADF typeFlatbed type

Operator Panel

 

 

Check

 

 

Function

 

 

Send to

Operator Panel

 

Scan / Stop

Function

Scan / Stop

 

 

Power

 

 

 

 

Power

Check

 

[Power] button

Send to

 

 

Function Number Display

2 Turn on your computer.

Function Number Display

[Power] button

For a SCSI connection, turn on the scanner and confirm that the Function Number Display shows “1.” Then, turn on your computer.

3 The scanner is automatically detected, and the [Found New Hardware] dialog box appears.

Select [Locate and install driver software (recommended)] to install the driver, following the on-screen instructions.

22