Fujitsu FMC-16LX FAMILY, FLASH-CAN-100 Configuration of the Evaluation-Board, MB90425 Pin MB90440

Change even page title here

Chapter 5 Configuration of the Evaluation-Board

5 Configuration of the Evaluation-Board

The board is configured to work with the MB90F598 microcontroller.

In order to set up the board follow these steps:

1.disconnect power supply disconnected !

2.Set jumper JP1 to provide Vcc, i.e. 5V to the board

3.If case one is connecting this board to an emulator, it is recommended to set jumper JP2 in order to provide 3.7V to the internal core.

4.Please set the mode pins 1-3 on S3 according to your MCU operating mode. ON stands for 0 and OFF for 1. E.g. MB90F598 all switches to OFF except no. 3.

5.Adjust both potentiometers (P1, P2) clockwise to their end position. (Check that Pin 8 of U4 and Pin 8 of U5 are grounded.)

6.Select the appropriate CAN interface for the microcontroller you are using by setting jumper JP3-JP6. Note that Pixx on the silk plot stands for Pinxx, i.e. the pin number. E.g. for the MB90F598, set JP3 and JP4 to connect Pin 2 and 3 in order to connect to MCU Pins 74 and 75, respectively.

Target	CAN0		CAN1		CAN2
Series
	RX0	TX0	RX1	TX1	RX2	TX2
MB90425	Pin 75	Pin 74	n.a.	n.a.	n.a.	n.a.
					Pin 72	Pin 71
MB90440	Pin 74	Pin 73	Pin 76	Pin 75
					(Not supported by
					Jumper 3-6 !)
MB90470	n.a.	n.a.	n.a.	n.a.	n.a.	n.a.
MB90540	Pin 74	Pin 73	Pin 76	Pin 75	n.a.	n.a.
MB90545	Pin 74	Pin 73	n.a.	n.a.	n.a.	n.a.
MB90550	n.a.	n.a.	n.a.	n.a.	n.a.	n.a.
MB90583	n.a.	n.a.	n.a.	n.a.	n.a.	n.a.
MB90590	Pin 75	Pin 74	Pin 97	Pin 98	n.a.	n.a.
MB90595	Pin 75	Pin 74	n.a.	n.a.	n.a.	n.a.

Table 1: Microcontroller pin-number of the CAN-interface

UG-900001-32 - 10 - © Fujitsu Microelectronics Europe GmbH