Fujitsu FLASH-CAN-100 manual MB90425, Handwire Pin 88 JP10.2 Handwire Pin 89 JP9.2, MB90435

Change odd page title here

Chapter 5 Configuration of the Evaluation-Board

7.Select the appropriate UART interface for the microcontroller you are using by setting jumper JP7-JP10.

8.Please use 1:1 cable for PC-connection.

Notes:

<Pixx on the silk plot stands for Pinxx, i.e. the pin number.

e.g. for the MB90F598, set JP10 and JP9 to connect Pin 1 and 2 in order use UART 1

<MB90425, MB90470, MB90480 and MB90580 series are not supported by jumpers. Please make handwired connections for these controllers.

Target Series	Asynch.	SIN / Jumper	SOT / Jumper
	Com.
MB90425	UART1	handwire Pin 88 – JP10.2	handwire Pin 89 – JP9.2
		(Not supported by Jumper JP7 - JP10)
MB90435	UART1	Pin 21 (JP10:1-2)	Pin 24 (JP9:1-2)
MB90440	UART1	Pin 21 (JP10:1-2)	Pin 24 (JP9:1-2)
		handwire Pin 27 – JP10.2	handwire Pin 28 – JP9.2
MB90470	UART0
		(Not supported by Jumper JP7 - JP10)
		see chapter 6.1 !
		handwire Pin 27 – JP10.2	handwire Pin 28 – JP9.2
MB90480	UART0
		(Not supported by Jumper JP7 - JP10)
		see chapter 6.1 !
MB90540	UART1	Pin 21 (JP10:1-2)	Pin 24 (JP9:1-2)
MB90545	UART1	Pin 21 (JP10:1-2)	Pin 24 (JP9:1-2)
MB90550	UART0	Pin 20 (JP8:1-2)	Pin 19 (JP7:1-2)
MB90580	UART0	handwire Pin 18 – JP10.2	handwire Pin 19 – JP9.2
		(Not supported by Jumper JP7 - JP10)
MB90590	UART0	Pin 16 (JP8:2-3)	Pin 14 (JP7:2-3)
MB90595	UART1	Pin 21 (JP10:1-2)	Pin 24 (JP9:1-2)

Table 2: MCU pin-number used, for the asynchronous boot-loader software

© Fujitsu Microelectronics Europe GmbH - 11 - UG-900001-32