Contents of the Setup Mode
This section describes the contents of the setup mode.
No | Item | Description | Selectable | Default |
|
|
| parameters |
|
|
|
|
|
|
1 | Double feed check | Double feed is detected by checking the | Tolerance: | No |
|
| document length one by one.** | No/10/15/20mm |
|
2 | IPC | Scanner automatically sets the recom- | Document: | No |
|
| mended reading parameters. 5 sets of | No/1/2/3/4/5 |
|
|
| recommended parameters are available. |
|
|
|
|
|
|
|
3 | Rest of abrasion | Abrasion counter can be reset. | - | - |
| counter |
|
|
|
|
|
|
|
|
4 | Pick start time | The time from the document Insertion to | Time: |
|
| setting | the start of picking is specified. User can | 0.2 to 29.8 sec | 1.0 sec |
|
| select most comfortable Pick start time for |
|
|
|
| the job. |
|
|
|
|
|
|
|
5 | The time that the scanner waits for next | Time: |
| |
|
| ducument insertion after last document | 27 values from | 30 sec |
|
| scanned can be specified. | 1 to 1999 sec |
|
6 | ADF front offset | Horizontal and vertical offset of the front | Offset: | Offset: |
| setting* | side image by ADF is specified. | H: 0 mm | |
|
|
| V: 0 mm | |
7 | ADF back offset | Horizontal and vertical offset of the back | Offset: | Offset: |
| setting* | side image by ADF is specified. | H: 0 mm | |
|
|
| V: 0 mm | |
8 | FB offset setting* | Horizontal and vertical offset of the FB | Offset: | Offset: |
|
| image is specified. | H: 0 mm | |
|
|
| V: 0 mm | |
9 | IPC/Memory status | The type of IPC option |
|
|
| display | and total memory installed are displayed. |
|
|
|
|
|
|
|
10 | SCSI ID setting | SCSI ID is selectable. | SCSI ID: |
|
|
|
| 0/1/2/3/4/5/6/7 | 5 |
*This offset means the deference from the value adjusted by automatic offset adjustment.
**The document length on ADF paper chute must be same. If the completely overlapped sheets are fed, the scanner cannot detects the double feed.
