TABLE 6 XCP Issues and Workarounds (Continued)

ID

Description

Workaround

 

 

 

RTIF1- The CLI 'showldap -c' (which displays 070914-019 current LDAP certificates) will show proper

data only when used with the same user account that had originally provided certificate information using 'setldap -c'. Any other user account will generate "Permission denied" error. Similarly, the XSCF Web’s LDAP Configuration pop-up screen will display no data, when a different user account is used.

RTIF1- On the User Account setting page on the User 070914-020 Manager screen, after the password change

resulted in "Change Password Error," when you click on the REFRESH button, there appears the error message "No user. The request is aborted."

RTIF1- During the Open BootPROM process, when 070914-021 you power off the domain, the error log of

Domain hang-up detected (level3) may be registered.

RTIF1- When you specify the domain ID or XSB 070914-023 number which are not supported on the

machine, there appears the parameter error message.

Use the same user account for all LDAP display or configuration operations, for both CLI and XSCF Web.

To change the password, select User Manager on the Menu again.

This error log can be safely ignored.

To specify the available domain ID or XSB number on the machine.

RTIF1- The XSCF firmware monitors itself and if it 071102-001 detects any inconsistencies, it forces an XSCF

reboot.

RTIF1- The snmp daemon might quit. 071102-002

RTIF1- After using the addfru(8) or replacefru(8) 071116-001 command to hotplug a CMU, further DR

operations might fail with a misleading message regarding the board being unavailable for DR.

There is no workaround. Allow the XSCF Unit to finish rebooting. It returns to normal operation within approximately 5 minutes.

To restart the snmp daemon, issue the command setsnmp enable.

When performing the addfru(8) and replacefru(8) commands, it is mandatory to run diagnostic tests. If you forget to run the diagnostic tests during addfru(8)/replacefru(8) then either run testsb(8) to test the CMU or remove the CMU/IOU with the deletefru(8) command and then use the addfru(8) command with the diagnostic tests.

RTIF1- Using the XSCF Web, when you selected COD, 071116-003 codusage details cannot be displayed correctly.

Use showcodusage(8) command to display the codusage.

SPARC Enterprise M4000/M5000 Servers Product Notes 17