Upgrading From XCP104x to XCP 1050 or Later The

following steps describe the case of upgrading to XCP1060.

Note – LAN connections are disconnected when the XSCF resets. It is recommended to use the XSCF serial connection to simplify the XCP upgrade procedure.

1.Log in to the XSCFU on an account with platform administrative privileges.

2.Verify that there are no faulted or deconfigured components by using the showstatus(8) command.

XSCF> showstatus

The showstatus(8) prompt will return if there are no failures found in the System Initialization. If anything is listed, contact your authorized maintenance representative before proceeding.

Note – Take information with using BUI or snapshot(8) command. This will be help in case any problem occurred in this procedure.

3.Power off all domains.

XSCF> poweroff -a

4.Confirm that all domains are stopped:

XSCF> showlogs power

5.Move the key position on the operator panel from Locked to Service.

6.Collect an XSCF snapshot to archive system status prior to upgrade.

XSCF> snapshot -tuser@host:directory

7.The BUI can be used to upload the XCP 1060 upgrade image.

SPARC Enterprise M4000/M5000 Servers Product Notes 31