Fujitsu MAP3147FC, MAP3735FC manual General Description, Automatic alternate block reassignment

General Description

(12)Automatic alternate block reassignment

If a defective data block is detected during read or write the IDD can automatically reassign its alternate data block.

(13)Programmable data block length

Data can be accessed in fixed-block length units. The data block length is programmable, and can be specified at initializing with a multiple of four within the range of 512 to 528 bytes.

Error rate increase

1.The drive format at factory shipment is generally 512 bytes.

2.The recoverable Error of the drive might increase when the format would be modified from 512 bytes to the following values:

516 bytes, 520 bytes, 524 bytes, 528 bytes.

3.The recoverable Error referred here is sense data (1-13-xx).

(14)Defective block slipping

A logical data block can be reallocated in a physical sequence by slipping the defective data block at formatting. This results in high speed contiguous data block processing without a revolution delay due to defective data block.

(15)High speed positioning

A rotary voice coil motor achieves fast positioning.

(16)Large capacity

A large capacity can be obtained from 3.5 type disk drives by dividing all cylinders into several partitions and changing the recording density on each partition (constant density recording). The disk subsystem with large capacity can be constructed in the good space efficiency.

(17)Start/Stop of spindle motor

Using the SCSI command, the host system can start and stop the spindle motor.

(18)Diagnosis

The IDD has a diagnostic capability which checks internal controller functions and drive operations to facilitate testing and repair.

1-4 C141-E163