Fujitsu MAX3147FC, MAX3073FC, MAX3036FC manual Port Discovery

5.4Checking Operation after Installation and Preparing the HDD for Use

(4)Control mode parameters

The following parameters are used to control the tagged queuing and error logging. a. Control mode parameters

	Parameter	Default value
• Queue algorithm modifier		0 (Execution sequence of
		read/write commands is
		optimized.)
• QErr:	Resume or abort remaining suspended	0 (command is resumed)
	commands after sense pending state
• DQue:	Disabling tagged command queuing	0 (enabled)

(5)Fibre channel control parameters

Refer to Subsection 4.1.4 "MODE SELECT (15)" of the Fibre Channel Interface Specifications for details.

Parameter	Default value
• DTOLI (Disable Target Original Loop Initialization)	0 (An Initializing LIP is issued
	when the HDD enters the
	Loop.)
• DTIPE (Disable Target Initiated Port Enable)	0 (The HDD does not have the
	Loop Port Enable primitive, so
	it enters the loop port.)
• ALWLI (Allow Login Without Loop Initialization)	0 (The HDD carries out
	confirmation of the address in
	the Loop Initialization
	process.)
• RHA (Require Hard Address)	0 (In the Loop Initialization
	process, try fixing a soft
	address.)
• DLM (Disable Loop Master)	0 (The HDD itself is permitted
	to become the Loop Master.)
• DDIS (Disable DIScovery)	0 (Before the INIT restarts
	task processing, it must wait
	for Address Discovery or
	Port Discovery.)
• PLPB (Prevent Loop Port Bypass)	0 (Receiving Loop Port bypass
	(LBP)/Loop Port Enable(LPE)
	Primitive, it controls Port
	Bypass circuit according to the
	received Primitive.)
• DTFD (Disable Target Fabric Discovery)	0 (Fabric connection is
	enabled.)

Note:

It is prohibited that "1" is specified in DTIPE and PLPB simultaneously.

If DTIPE=PLPB=1 is specified, it responds with CHECK CONDITION (ILLEGAL REQUEST, VALID FIELD IN THE PARAMETER LIST.)

C141-E234 5-15