Installing and removing a board, Installing a board | Fujitsu P300

■Installing and removing a board

CAUTION

Please take note of the “Information about boards” chapter.

In the upper three slots you can install boards with a length of up to 230 mm, and in the lower slot boards with a length of up to 315 mm.

The number, position and arrangement of the board slots on the mainboard can be found in the technical manual for the mainboard. Boards may already be installed when the device is shipped.

Installing a board

1Open the casing (see "Opening the casing").

1

2Remove the screw (1).

3Remove the rear slot cover plate from the slot (2).

Do not dispose of the cover plate. For cooling, protection against fire and in order to comply with EMC regulations, you must refit the cover plate if you remove the board. The top and the lowest slot are suitable for low-profile cards with an adapter.

4 Take the new board out of its packaging.

30

Image 44

Fujitsu P300 user manual Installing and removing a board, Installing a board, Take the new board out of its packaging

Contents

Deskpower P300 Series User’s Manual Important Safety Instructions Iii Before reading this manual For Safe Operation Using this Product for High-Safety Applications Backing Up the Data Microsoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Safety Important NotesManufacturer’s notes Energy saving FCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorCleaning the keyboard and the mouse Transporting the PC Disposal and recycling Reference to products Xii Organization of This Manual Before Reading This Manual Contents Technical Data System Expansions Chapter Steps for Initial Setup Preparing for UseUnpacking and Checking the Delivery External devices Setting Up the PC Connecting the keyboardConnecting standard keyboard Connect the Monitor, Mouse and Keyboard Connecting USB mouse Connecting the mouseConnecting a PS/2 mouse Connecting the PC to the Mains Voltage Devices with main power switchDevices without main power switch Notch for inserting the screwdriver Initial Switch-on Software will be Installed Switching on monitor and PC Installing the software Disconnecting cables Connecting External DevicesConnecting cables LAN Connections on the system unit Connecting external devices to the serial port Connecting external devices to the parallel portSettings of the serial port Settings of the parallel port Operation Switching On the PC On devices with main power switchOn devices without main power switch Operation Switching Off the PC Indicators on the PC Hard disk indicatorPower-on indicator Floppy disk indicator Keyboard Point Floppy Disks Working with Floppy Disks Settings in Bios Setup Access Protection Under WindowsProperty and Data Protection Anti-theft protection Bios Setup Security Functions Troubleshooting Tips Troubleshooting and Tips Installing New SoftwareMains voltage supply is faulty Internal power supply overloaded Screen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Windows 2000/XP Wrong RAM modules have been inserted PC cannot be switched off with the power button Time and/or Date is Not CorrectTips Out of system resourcesPage System Expansion System Expansions Information about boards Opening the casing Closing the casing Take the new board out of its packaging Installing and removing a boardInstalling a board Page Removing a board Page Installing an Additional Serial Port Low-Profile boardsMounting slot adapter Removing slot adapter Installing and Removing the Hard Disk Drives Removing a hard disk drive Installing a hard disk drive Replacing Lithium Battery Page Technical Data Technical Data List of Specifications Dimensions Weight Electrical Data Environmental conditions