MYRICA P42-1A / P42-2 / P50-2
Troubleshooting in PC mode
Having this problem? | Check the following points: | |
|
| |
Message: | ► Check the setting of the picture signal | |
No Signal / Keine Eingabe | source. | |
► Check whether the antenna or data cable | ||
| ||
| is correctly connected. | |
|
| |
Message: | The input signal (horizontal frequency and | |
Out of range | refresh rate) at the displayed input does not | |
correspond to the technical plasma TV data. | ||
| ► Adjust the video frequency range using | |
| the computer software (see | |
| documentation for your computer or your | |
| graphics card). | |
|
| |
Picture position is not correct | The plasma TV recognises an undefined mode | |
| (see "Preset operating modes (PC)"). | |
| ► Use the OSD function Geometry/Auto to | |
| carry out the | |
| plasma TV. | |
| ► Set the picture position with the OSD | |
| menu. | |
| These functions are only available when PC is | |
| selected as the signal source. | |
|
| |
Picture is shaking | ► Check whether the data cable for the | |
| plasma TV is correctly attached to the | |
| monitor port on the computer. | |
|
|
| 42 - English | |
Downloaded From |
| |
