Fujitsu RX300 S2 4

4Checking location before installing the server

For details on installing the rack, refe r to the "Installation

Guide for the RACK" and the ma nual provided with the

rack.

nConditions

When installing t his server avoid the following areas.

- Humid, dusty, or oily areas- Poorly ventilated areas- Areas close to re or other sources of heat- Areas close to water- Are as clo se to direct sunlig ht or near heating appli ances- Areas with a temperature of below 10°C or above 35°C- Areas with humidity of less than 20% or more than 80%- Salty areas- Areas where corrosive gas is generate d- Areas where cables become trip hazards- Are as whe re str ong ma gnetic elds are ge nerated, such as near TVs and speakers- Areas w here the d evice is no t sta ble a nd co uld t ip over and hurt somebody

nInstalling the server to the rack

Make sure to contact an ofce lis ted in the "Contact In-

formation" before attempting to ins tall or remove a server

from the rack.

1Open both the front and rear doors of

the rack.

2Check where to attach the slide rail

and rack nuts

Attach the slide rail to the f ront and rear brackets.

Attach the rack nuts to the f ront brackets.

��

�

3Remove the inner rail from the slide

rail

Press down the lock in the cente r of the inner rail

to remove.

�

��

4Attach the inner rail to the server.

��

Left and right inner rails are dif ferent.

Check the letter at the lock par t for correct installation.

5Remove the athead screws xing the

slide rail bracket, and attach binding

head screws.

Two on the front: Tightly fasten where the athead

screws were used.

Two on the rear: Loosely fasten at the location in

the following gure.

��

- In dusty area, dust will quickly stic k to the front and

backside of the server. Since this can c ause failure,

changing the installation place i s recommended.

- Be sure to secure racks and cannect stabilizers to prevent

the device tipping over.