6
8Turning off the power and installing optional devices
Install optional devices to be installed after the OS installation, such as UPS device.
������������
"Chapter 7 Install ing Internal O ptions"
9Hints for error handling
In preparation of a failure occurring, set the fol-
lowing.
������������
"Chapter 5 Operatio ns after OS
Installation"
- Set to collect memory dump
If the memory dump is set, d ebugging information i s au-
tomatically saved when the STOP er ror occurs in the sys-
tem. This helps to analyz e the cause of error occur rence.
- Create a system restoration disk
When the system le or syste m environments are da m-
aged, the system can be rec onstructed with th e content
saved in the system restorat ion disk.
- Store system settings
By storing the BIOS setting s, the original infor mation can
be recovered when the setti ng information is lost.
When this server is i nstalled, store and save the BIOS set-
tings by yourself. Be caref ul not to lose the stored BIOS
setting informat ion as you must provide this when you
contact an ofce listed i n the "Contact Informat ion".
When the settings are completed, make sure to
check notes before operation.
������������
"5.5 Note before Operating t he Server"
For details about maintenance after operations have
started, refer to "User's Guide Chapter 9 Op erating
and Maintenance".
1Check that no medium is inserted in
the oppy disk drive or CD-ROM drive.
2Exit the operating system (OS).
After the OS is exited, the s erver is automatically
turned off.
When the power of the server is not off af ter the OS
is exited, press the power switch on th e front of the
server.
3Power off the peripheral devices, such
as the display.
4Install the optional devices.
After optional devices are installed, set the BIO S
setup utility or WebBIOS as required.
For details about setting procedures, refer to the
"User's Guide Chapter 8 Hardware Congurat ion/
Utilities" and "PRIMERGY RX300 S2 On board
SCSI RAID User's Guide".
When turning on the server again after tur ning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after be ing turned
off, an error will occur that may cause damage.
10 Support and Service
lPRIMERGY information
The latest PRIMERGY, driver, and software i nformation is
available at the address below. Use as necessar y.
http://primergy.fujitsu.com
lBefore requesting repairs
If an error occurs i n this server, refer to "User's Guide 9.2
Troubleshooting". If problems can still not be solved, con-
tact an ofce listed in the "C ontact Information".
When contacting the of ce listed in the "Contact Infor ma-
tion", inform them of the product ID and a ma nufactures
number which are detailed on lab els on the base of the
server.
Also read the points to note abou t requesting repairs before -
hand in "User's Guide 9.9.2 Contacting Mainte nance Sup-
port".
Print the "Congur ation Sheets" - "Accident sheet" and en-
ter the checked information .
Be careful not to lose this sheet , as you must provide this
information when you contact a n ofce listed in the "Con-
tact Information".
�� ��������
������ ��
����������
�������������
������