Fujitsu S7100 Video OUT Port TV OUT, Ieee 1394 Port, HEADPHONE/LINE OUT Jack, External Video Port

S7110.book Page 54 Monday, March 20, 2006 1:56 PM

L i f e B o o k S 7 1 0 0 N o t e b o o k

S-VIDEO OUT PORT (TV OUT)

The S-Video port allows you to connect and use directly any S-Video device, such as a VCR or television. The S-Video standard provides for a higher quality picture than NTSC or PAL. In order to connect an S-Video device, follow these easy steps: (Figure 4-26)

1.Attach the mini S-Video cable adapter (included with your system accessories) to the S-Video cable from the device.

2.Align the connector with the port opening.

3.Push the connector into the port until it is seated.

When S-Video is connected, you can toggle the S-Video device on and off by pressing the [F11] key while holding down the [Fn] key.

Mini S-Video

Adapter

S-Video Cable

Figure 4-26. Connecting the S-Video Cable Adapter

IEEE 1394 PORT

The 4-pin 1394 port allows you to connect digital devices that are compliant with IEEE 1394 standard. The IEEE 1394 standard is easy to use, connect, and discon- nect. This port can allow up to 400 Mbps transfer rate. A third-party application may be required to operate your digital device with the 1394 port.

2.Push the connector into the port until it is seated. (Figure 4-27)

HEADPHONE/LINE OUT JACK

The headphone/line-out jack supports 2-channel High Definition (HD) audio for greatly a enhanced multi- media experience.

The headphone/line out jack allows you to connect headphones or powered external speakers. In order to connect headphones or speakers follow these easy steps:

1.Align the connector (3.5 mm stereo mini-jack) with the port opening.

2.Push the connector into the port until it is seated.

If you plug headphones into the headphone jack, you will disable the built- in stereo speakers.

MICROPHONE/STEREO LINE-IN JACK

The microphone/stereo line-in jack allows you to connect an external microphone or an external audio source such as an audio cassette player to your note- book. Your audio device must be equipped with a 1/8" (3.5 mm) stereo mini-plug in order to fit into the stereo line-in jack of your notebook. To connect a external audio source: (See Figure 2-5 on page 8 for location)

1.Align the connector with the port opening.

2.Push the connector into the port until it is seated.

Turn down the audio volume when connecting electronic devices to the line-in jack. The internal speakers might break if unexpected large sounds are input.

Figure 4-27. Connecting an IEEE 1394 Device

The 1394 port in this system uses a four- pin configuration. If you want to interface with devices which use a six-pin configura- tion, you will need to purchase an adapter.

In order to connect a 1394 device, follow these steps:

1. Align the connector with the port opening.

54

EXTERNAL VIDEO PORT

The external video port allows you to connect an external monitor or LCD projector. In order to connect an external video device, follow these easy steps: (See Figure 2-7 on page 10 for location)

1.Align the connector with the port opening.

2.Push the connector into the port until it is seated.

3.Tighten the two hold-down screws, located on each end of the connector.

Pressing the [Fn] + [F10] keys allows you to change your selection of where to send your display video. Each time you press the key combination, you will step to the next choice, starting with the built-in display panel only, moving to the external device only, finally moving to both the built-in display panel and an external device.