Fujitsu S7100 manual Utility on page 29 for more information, Video Problems, for location

S7110.book Page 63 Monday, March 20, 2006 1:56 PM

		T r o u b l e s h o o t i n g
Problem	Possible Cause	Possible Solutions
The Suspend/Resume	There may be a conflict with	Close all applications and try the button again.
button does not work.	the application software.
(continued)
The system powers up, and	The boot sequence settings	Set the operating source by pressing the [ESC] key
displays power on informa-	of the setup utility are not	while the Fujitsu logo is on screen or use the [F2]
tion, but fails to load the	compatible with your	key and enter the setup utility and adjust the source
operating system.	configuration.	settings from the Boot menu. (See BIOS Setup
		Utility on page 29 for more information)
	You have a secured system	Make sure you have the right password. Enter the
	requiring a password to load	setup utility and verify the Security settings and
	your operating system.	modify them as accordingly. (See BIOS Setup Utility
		on page 29 for more information)
	Internal hard drive was	Use the BIOS setup utility or Primary Master
	not detected.	submenu, located within the Main menu, to try to
		auto detect the internal hard drive.
An error message is	Power On Self Test (POST) has	See the Power On Self Test (POST) messages to
displayed on the screen	detected a problem.	determine the meaning and severity of the problem.
during the notebook		Not all messages are errors; some are simply status
(boot) sequence.		indicators. (See Power On Self Test Messages on
		page 66 for more information)
Your notebook appears to	BIOS setup changes were not	Make sure you select Save Changes And Exit when
change setup parameters	saved when you made them	exiting the BIOS setup utility.
when you start it.	and exited the BIOS setup
	utility returning it to
	previous settings.
	The BIOS CMOS hold-up	Contact your support representative for repairs.
	battery has failed.	This is not a user serviceable part but has a normal
		life of 3 to 5 years.
Your system display won’t	The system may be password-	Check the status indicator panel to verify that the
turn on when the system is	protected.	Security icon is blinking. If it is blinking, enter your
turned on or when the		password.
system has resumed.
Video Problems
The built-in display is	Something is pushing on the	Clear the Closed Cover switch. (See figure 2-4 on
blank when you turn on	Closed Cover switch.	page 6 for location)
your LifeBook notebook.
	The notebook is set for an	Pressing [F10] while holding down the [Fn] key
	external device only.	allows you to change your selection of where to
		send your display video. Each time you press the
		combination of keys you will step to the next
		choice. The choices, in order are: built-in display
		only, external monitor only, both built-in display
		and external monitor.
	The angle of the display and	Move the display and the brightness control until
	the brightness settings are not	you have adequate visibility.
	adequate for your lighting
	conditions.

63