Fujitsu S7100 manual Memory Problems, Modem Problems, Parallel, Serial, and USB Device Problems

S7110.book Page 60 Monday, March 20, 2006 1:56 PM

L i f e B o o k S 7 1 0 0 N o t e b o o k

Problem	Possible Cause		Possible Solutions
You have installed an	Your operating system soft-	Check your device and operating system docu-
external keyboard or	ware is not set up with the	mentation and activate the proper driver.
mouse, and it does not	correct software driver.
seem to work.
(continued)
You have connected an	Your operating system soft-	Check your device and operating system
external keyboard or a	ware is not set up with the	documentation and activate the proper driver.
mouse and it seems to be	correct software driver for that
locking up the system.	device.
	Your system has crashed.	Try to restart your notebook. I
Memory Problems
Your Power On screen, or	Your memory upgrade module	Remove and re-install your memory upgrade
Main menu of the BIOS	is not properly installed.	module. (See Memory Upgrade Module on page 45
setup utility information,		for more information)
does not show the correct
	You have a memory failure.	Check for Power On Self Test (POST) messages.
amount of installed
		(See Power On Self Test Messages on page 66 for more
memory.
		information)
Modem Problems
Messages about modem	Messages about modem	See your application software documentation for
operation.	operation are generated by	additional information.
	whichever modem application
	is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel	The device is not properly	Remove and re-install the device. (See Device Ports
port device, a serial port	installed.	on page 52 for more information)
device or a USB device.
	The device may have been	Close the application and restart your notebook.
Your LifeBook notebook
	installed while an application
does not recognize the
	was running, so your notebook
device, or the device does
	is not aware of its installation.
not seem to work properly.
	Your device may not have the	See your software documentation and activate the
	correct software driver active.	correct driver.
	You may have the wrong I/O	See your device documentation and software docu-
	address selected for your	mentation to determine the required I/O address.
	device.	Change the settings in the BIOS setup utility. (See
		BIOS Setup Utility on page 29 for more information)
	Your device and another device	Check all I/O addresses located within the BIOS
	are assigned the same I/O	setup utility and any other installed hardware or
	address.	software to make sure there are no duplications.
	Parallel port is set to output	Check parallel port setting in the BIOS and set to
	only.	bi-directional or ECP.
PC Card Problems
A card inserted in the PC	The card is not properly	Remove and re-insert the card. (See PC Cards/
Card slot does not work or	inserted.	ExpressCards™ on page 43 for more information)
is locking up the system.
60