Fujitsu T5440 Hot-Plug a Nonmirrored Disk

24 SPARC Enterprise T5440 Server Administration Guide • July 2009

5. To check the status of the RAID rebuild, type:

For example:

This example indicated that RAID volume c0t1d0 is resynchronizing. If you issue

the command again once synchronization is complete and the disk is back online,

the RAID status changes from RESYNCING to OK.

Related Information

■“Hot-Plug a Nonmirrored Disk” on page 24

■“Delete a Hardware RAID Volume”on page 21

▼Hot-Plug a Nonmirrored Disk

1. Verify which hard drive corresponds with which logical device name and

physical device name.

See “Disk Slot Numbers” on page 20.

Caution – Toavoid data corruption or loss, ensure that no applications or processes

are accessing the hard drive.

#raidctl

RAID Volume RAID RAID RAID

Volume Type Status Disk Status

-----------------------------------------------------------------

c0t1d0 IM RESYNCING c0t1d0 OK

c0t2d0 OK

Contents

Main Page Page Please Recycle Page Page Contents Page Page Page Preface Note For Safe Operation Structure and Contents of This Manual Related Documentation Note update on your product. UNIX Commands Text Conventions Prompt Notations Fujitsu Welcomes Your Comments Basic Administrative Tasks Initial System Setup Communicating With the System ILOM Overview Log In to ILOM Note Log In to the System Console Display the ok Prompt Caution Display the ILOM ->Prompt System Console Output Options Access the System Console Through a Local Graphics Monitor Performing Common Tasks Power On the System Note Power Off the System Note Reset the System Update the Firmware image Page Page Manage Disk Volumes Hardware RAID Support Creating RAID Volumes Create a Hardware Mirrored Volume Create a Hardware Mirrored Volume of the Default Boot Device Note Create a Hardware Striped Volume Note Caution Configure and Label a Hardware RAID Volume for Use in the Solaris Operating System Page Disk Slot Numbers Removing Hardware RAID Volumes Delete a Hardware RAID Volume Page Hot-Plug a Mirrored Disk Hot-Plug a Nonmirrored Disk Caution Page Page Manage the System Searching for Faults Log In to ILOM Note Display System Faults Run Full POST Diagnostics on Reset Locate the System Bypassing Minor Faults Automatic System Recovery Enable Automatic System Recovery Disable Automatic System Recovery View Components Affected by ASR Clearing Faults Clear Component Fault Messages Managing Devices Unconfigure a Device Manually Configure a Device Manually Devices and Device Identifiers Page Use Logical Domains Software Understanding Logical Domains Software Logical Domain Software Overview Logical Domain Configurations Logical Domains Software Requirements Note Operating the Solaris OS With Logical Domains Note OpenBoot Firmware Not Available After Solaris OS Has Started if Domaining Is Enabled Power-Cycle a Server Save Your Current Logical Domain Configurations to the SC Result of an OpenBoot power-off Command Result of Solaris OS Breaks Results From Halting or Rebooting the Control Domain Note Page Page Page Note Page Page Page Page Page Page Index Symbols A D F