Fujitsu T5440 Note

42 SPARC Enterprise T5440 Server Administration Guide • July 2009

Note – The question in TABLE: Expected Behavior of Halting or Rebooting the

Control (primary) Domain on page 42 regarding whether domaining is enabled

pertains only to the UltraSPARC T1 processors. Otherwise, domaining is always

enabled.

TABLE: Expected Behavior of Halting or Rebooting the Control (primary) Domain

Command

Domaining

Enabled?

Other Domain

Configured? Behavior

halt Disabled N/A ForUltraSPARC T1 Processors:

Drops to the ok prompt.

Enabled No For UltraSPARC T1 Processors:

See message in 02.

For UltraSPARCT2 Processors:

Host poweredoff and stays off until powered

on at the SC.

Enabled Yes Soft resets and boots up if the variable

auto-boot?=true. Soft resets and halts at

ok prompt if the variable auto-boot?=

false.

reboot Disabled N/A ForUltraSPARC T1 Processors:

Powers off and powers on the host.

Enabled No For UltraSPARC T1 Processors:

Powers off and powers on the host.

For UltraSPARCT2 Processors:

Reboots the host, no power off.

Enabled Yes ForUltraSPARC T1 Processors:

Powers off and powers on the host.

For UltraSPARCT2 Processors:

Reboots the host, no power off.

shutdown -i 5 Disabled N/A For UltraSPARCT1 Processors:

Powers off the host.

Enabled No Host powered off, stays offuntil powered on

at the SC.

Enabled Yes Soft resets and reboots.

Contents

Main Page Page Please Recycle Page Page Contents Page Page Page Preface Note For Safe Operation Structure and Contents of This Manual Related Documentation Note update on your product. UNIX Commands Text Conventions Prompt Notations Fujitsu Welcomes Your Comments Basic Administrative Tasks Initial System Setup Communicating With the System ILOM Overview Log In to ILOM Note Log In to the System Console Display the ok Prompt Caution Display the ILOM ->Prompt System Console Output Options Access the System Console Through a Local Graphics Monitor Performing Common Tasks Power On the System Note Power Off the System Note Reset the System Update the Firmware image Page Page Manage Disk Volumes Hardware RAID Support Creating RAID Volumes Create a Hardware Mirrored Volume Create a Hardware Mirrored Volume of the Default Boot Device Note Create a Hardware Striped Volume Note Caution Configure and Label a Hardware RAID Volume for Use in the Solaris Operating System Page Disk Slot Numbers Removing Hardware RAID Volumes Delete a Hardware RAID Volume Page Hot-Plug a Mirrored Disk Hot-Plug a Nonmirrored Disk Caution Page Page Manage the System Searching for Faults Log In to ILOM Note Display System Faults Run Full POST Diagnostics on Reset Locate the System Bypassing Minor Faults Automatic System Recovery Enable Automatic System Recovery Disable Automatic System Recovery View Components Affected by ASR Clearing Faults Clear Component Fault Messages Managing Devices Unconfigure a Device Manually Configure a Device Manually Devices and Device Identifiers Page Use Logical Domains Software Understanding Logical Domains Software Logical Domain Software Overview Logical Domain Configurations Logical Domains Software Requirements Note Operating the Solaris OS With Logical Domains Note OpenBoot Firmware Not Available After Solaris OS Has Started if Domaining Is Enabled Power-Cycle a Server Save Your Current Logical Domain Configurations to the SC Result of an OpenBoot power-off Command Result of Solaris OS Breaks Results From Halting or Rebooting the Control Domain Note Page Page Page Note Page Page Page Page Page Page Index Symbols A D F