ALOM-to-ILOM Command Reference 49
TABLE: ALOM CMT Shell Status and Control Commands
ALOM CMT Command Summary Comparable ILOM Command
showenvironment Displays the environmental status of
the host server.This information
includes system temperatures, power
supply status, front panel LED status,
hard disk drive status, fan status,
voltage, and current sensor status.
show –o table –level all
/SYS
showpower [–v] Displays power metrics for the host
server.
show /SP/powermgmt
shownetwork [–v] Displays the current network
configuration information. The –v
option shows additional information
about your network, including
information about your DHCP server.
show /SP/network
console
console –f
Connects to the host system console.
The –f option forces the console write
lock from one user to another.
start /SP/console
No equivalent in ILOM
break –c
break –D
Drops the host server from running
the Solaris OS software into OpenBoot
PROM or kmdb depending upon the
mode in which the Solaris software
was booted.
set /HOST
send_break_action=break
set /HOST
send_break_action=dumpcore
bootmode [normal]
[reset_nvram] [config=
configname][bootscript =
string]
Controls the host server OpenBoot
PROM firmware method of booting.
set /HOST/bootmode property=
value
[where property is state,
config, or script]
flashupdate –s IPaddr –f
pathname [–v]
Downloads and updates system
firmware (both host firmwareand
ALOM CMT firmware). For ILOM,
ipaddr must be a TFTP server.If DHCP
is used, ipaddr can be replaced by the
name of the TFTP host.
load –source
tftp://ipaddr/pathname