Fujitsu Installing the XG2000 in a rack, Set up requirements, Take the XG2000 out of its box

Set up requirements

Only use the XG2000 under the temperature, humidity and other environmental conditions specified in "A.2 Installation Specifications (P.42)". Using the XG2000 outside the following ranges can shorten the lifetime or cause the failure of the XG2000.

•Temperature (5 - 40°C)

•Humidity (20 - 80%RH)

When installing the XG2000 in a rack, note the following.

•Certain types of racks cannot be used. To check whether the XG2000 can be installed in a given rack, contact the vendor's service department.

CAUTION

•Remember that when an installed unit is operating, the temperature inside the rack will be higher than the external ambient temperature, particularly if the rack con- tains multiple units. The rack's internal ambient temperature should not be allowed to exceed the maximum ambient temperature specified for each installed unit. The maximum ambient temperature allowed for the XG2000 is 40°C.

•A certain amount of air is required for the XG2000 to operate safely. Make sure that adequate ventilation is provided and that the front and rear air vents are not obstructed.

•Be careful that the rack is able to supply sufficient power for all the installed units. To avoid overloading the rack, check the power requirements specified for the each installed unit. The power requirement of the XG2000 is 0.22KVA.

•Installing the XG2000 in a rack may cause the entire rack to become unstable. To avoid this, fix the rack to the wall or floor as appropriate.

•Check that all the installed units are correctly grounded. Special care should be taken if the unit's power supply is not drawn directly from the distribution board (such as when a power strip is used, for example). When multiple devices are con- nected to a single power strip, the combined leakage currents can overwhelm the grounding capacity of the power strip.

•Set the XG2000 nearby the AC outlet, and keep it within the reach of the power cord for pulling it easily. The XG2000 is shut off by pulling the power cord off the AC outlet.

2-2-2 Installing the XG2000 in a rack

The following explains how to install the XG2000 in a 19-inch rack.

1. Take the XG2000 out of its box.

26

Installation and Operation