Removing the slot cover

when slot cover screwed in place

•Loosen the screws on the slot cover in question and remove the cover.

•Install the expansion module in accordance with the manufacturer’s instructions.

•Fix the module in place with the screws from the slot cover.

•Follow the opening process in reverse to close the PC.

where slot cover pre-punched

•Insert a slot screwdriver in the crack visible from above and turn inwards with gentle pressure to loosen the slot cover, then pull off with a set of flat nose pliers. Any loose metal cuttings are to be removed.

5.Install the expansion module in accordance with the module manufacturer’s instructions.

6.Follow the opening process in reverse to close the PC.

7.Configure the BIOS setup if necessary (e.g. IRQ).

8.Install the required driver for the expansion module.

CAUTION! There is a risk of injury when installing and removing modules due to sharp edges caused by pulling off the slot cover.

•If you wish to remove the retrofitted module at a later date, please close the resulting opening immediately with a slot cover available from a specialist supplier.

66