Fujitsu Siemens Computers S2210 manual Shutdown and Startup Problems

		T r o u b l e s h o o t i n g
Problem	Possible Cause	Possible Solutions
The batteries seem to	The power savings features may	Check the power management and/or setup utility
discharge too quickly.	be disabled.	settings in the Power Savings menu and adjust
(continued)		according to your operating needs.
	The brightness is turned all	Turn down the brightness adjustment. The higher
	the way up.	the brightness the more power your display uses.
	The batteries are very old.	Replace the batteries.
	The batteries have been	Replace the batteries.
	exposed to high temperatures.
	The batteries are too hot or too	Restore the notebook to normal operating tempera-
	cold.	ture. The Charging icon on the Status Indicator
		panel will flash when the battery is outside its
		operating range.
Shutdown and Startup Problems
The Suspend/Resume	The Suspend/Resume button is	Enable the button from the setup utility.
button does not work.	disabled from the Advanced
	submenu of the Power menu of
	the setup utility.
	You did not hold the button in	Hold the button longer. This may need to be a few
	long enough.	seconds if your application is preventing the CPU
		from checking for button pushes.
	There may be a conflict with	Close all applications and try the button again.
	the application software.
The system powers up, and	The boot sequence settings of	Set the operating source by pressing the [ESC] key
displays power on informa-	the setup utility are not	while the Fujitsu logo is on screen or use the [F2]
tion, but fails to load the	compatible with your	key and enter the setup utility and adjust the source
operating system.	configuration.	settings from the Boot menu. (See BIOS Setup
		Utility on page 27 for more information)
	You have a secured system	Make sure you have the right password. Enter the
	requiring a password to load	setup utility and verify the Security settings and
	your operating system.	modify them as accordingly. (See BIOS Setup Utility
		on page 27 for more information)
	Internal hard drive was	Use the BIOS setup utility or Primary Master
	not detected.	submenu, located within the Main menu, to try to
		auto detect the internal hard drive.
An error message is	Power On Self Test (POST) has	See the Power On Self Test (POST) messages to
displayed on the screen	detected a problem.	determine the meaning and severity of the problem.
during the notebook		Not all messages are errors; some are simply status
(boot) sequence.		indicators. (See Power On Self Test Messages on
		page 62 for more information)
Your notebook appears to	BIOS setup changes were not	Make sure you select Save Changes And Exit when
change setup parameters	saved when you made them	exiting the BIOS setup utility.
when you start it.	and exited the BIOS setup
	utility returning it to previous
	settings.
	The BIOS CMOS hold-up	Contact your support representative for repairs.
	battery has failed.	This is not a user serviceable part but has a normal
		life of 3 to 5 years.

59