Fujitsu Siemens Computers S2210 manual Video Problems

L i f e B o o k S 2 0 0 0 N o t e b o o k

Problem	Possible Cause	Possible Solutions
Your display won’t turn on	The system may be password-	Check the status indicator panel to verify that the
when the system is turned	protected.	Security icon is blinking. If it is blinking, enter your
on or when it has resumed.		password.
Video Problems
The built-in display is	The notebook is set for an	Pressing [F10] while holding down the [Fn] key
blank when you turn on	external monitor only.	allows you to change your selection of where to
your LifeBook notebook.		send your display video. Each time you press the
		combination of keys you will step to the next
		choice. The choices, in order are: built-in display
		only, external monitor only, both built-in display
		and external monitor.
	The angle of the display and the	Move the display and the brightness control until
	brightness settings are not	you have adequate visibility.
	adequate for your lighting
	conditions.
	The power management time-	Press any button the keyboard, or move the mouse
	outs may be set for very short	to restore operation. If that fails, push the Power/
	intervals and you failed to	Suspend/Resume button. (The display may be shut
	notice the display come on	off by Standby mode, Auto Suspend or Video
	and go off again.	Timeout)
The notebook turned on	Power On Self Test (POST) has	Contact your support representative.
with a series of beeps and	detected a failure which does
built-in display is blank.	not allow the display to operate.
The display goes blank by	The notebook has gone into	Press any button on the keyboard, or move the mouse
itself after you have been	Video timeout, Standby mode,	to restore operation. If that fails, push the Power/
using it.	Suspend mode or Save-to-Disk	Suspend/Resume button. Check your power manage-
	mode because you have not	ment settings, or close your applications and go to the
	used it for a period of time.	Power Savings menu of the setup utility to adjust the
		timeout values to suit your operation needs. (See
		BIOS Setup Utility on page 27 for more information)
	The power management time-	Press any button on the keyboard, or move the mouse
	outs may be set for very short	to restore operation. If that fails, push the Power/
	intervals and you failed to	Suspend/Resume button. (The display may be shut
	notice the display come on	off by Standby Mode, Suspend or Video Timeout)
	and go off again.
Your system display won’t	The system may be password-	Check the status indicator panel to verify that the
turn on when the system is	protected.	Security icon is blinking. If it is blinking, enter your
turned on or when the		password.
system has resumed.
The built-in display does	A foreign object, such as a	Remove all foreign objects from the keyboard.
not close.	paper clip, is stuck between the
	display and the keyboard.
The built-in display has	If the spots are very tiny and	This is normal; do nothing.
bright or dark spots.	few in number, this is normal
	for a large LCD display.
	If the spots are numerous or	Display is faulty; contact your support representative.
	large enough to interfere with
	your operation needs.

60