Advanced Operation
Autoscan
(Receiving Channels)
Autoscan receives available digital channels and stores them in a channel map.
CAUTION:
•If autoscan is skipped, digital channels may not be received correctly.
1 Press [SETUP].2Select “CHANNEL” using [ K / L], then press [OK].3Select “AUTOSCAN” using [ K / L], then press [OK].CHANNEL
EXIT
ADD/DELETE
CHANNEL
ANTENNA
TIME
AUTOSCAN
DETAIL
RF OUT
INITIAL
4Select “AUTOSCAN” using [ K / L], then press [OK].AUTOSCAN
To cancel during scanning:
Press [SETUP] or [OK]
NOTE:
If canceled, some channels not yet scanned may not be received. We recommend completing autoscan.
When you want to completely refresh the channel map, delete all the channels, then do the autoscan again. See “Adding/Deleting Channels” on this page for details.
When “NO SIGNAL” appears on the TV screen:
Verify the antenna connection, then scan again.
The STB tunes in channel
Adding/Deleting Channels
Add or delete desired channels in the channel map.
CAUTION:
•You cannot recover the deleted channels once they are deleted unless you perform the autoscan again.
1 Press [SETUP].
EXIT
CHANNEL
AUTOSCAN will rescan all channels. This may take a while to complete.
2Select “CHANNEL” using [ K / L], then press [OK].
TIME BACK
DETAIL AUTOSCAN
INITIAL
AUTOSCAN
The system is now scanning.
|
|
|
|
|
|
|
|
12% |
| Channel Found | |
|
|
|
|
| EXIT |
|
|
|
|
|
|
STB starts receiving available digital channels and stores them in the channel
map.
When the scanning is complete, “AUTOSCAN C OMPLETED” will be indicated.
After autoscan is complete, use [CH K / L ] to verify whether STB is receiving channels properly.
SETUP
EXIT |
|
|
| ADD/DELETE | |
CHANNEL |
| |
| ANTENNA | |
TIME |
| |
| AUTOSCAN | |
|
| |
DETAIL |
| RF OUT |
INITIAL |
|
|
CHANNEL
EXIT |
|
|
|
|
|
| |
CHANNEL |
| ADD/DELETE |
|
| ANTENNA | ||
|
| ||
TIME |
| AUTOSCAN | |
|
| ||
DETAIL |
| RF OUT | |
INITIAL |
|
|
|
18
EN