FIGURE A |
|
EXAMPLE OF ANTENNA GROUNDING AS PER | ANTENNA LEAD |
NATIONAL ELECTRICAL CODE | |
| IN WIRE |
ANTENNA
GROUND CLAMP DISCHARGE UNIT (NEC SECTION
ELECTRIC SERVICE |
|
EQUIPMENT |
|
| GROUNDING |
NEC - NATIONAL | CONDUCTORS |
ELECTRICAL CODE | (NEC SECTION |
POWER SERVICE GROUNDING ELECTRODE | GROUND CLAMPS |
| |
SYSTEM (NEC ART 250, PART H) |
|
conductors, location of
connection to grounding electrodes, and requirements for the grounding electrode. (Fig. A)
14.Lightning - For added protection for this product receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to this product due to lightning and
15.Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
16. Overloading - Do not overload wall outlets and extension
cords as this can result in a risk of fire or electric shock.
17.Object and Liquid Entry - Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on this product.
18.Servicing - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
19.Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:
a.When the
b.If liquid has been spilled, or objects have fallen into this product.
c.If this product has been exposed to rain or water.
d.If this product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore this product to its normal operation.
e.If this product has been dropped or damaged in any way.
f.When this product exhibits a distinct change in
20. Replacement Parts - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards.
21.Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform routine safety checks to determine that this product is in proper operating condition.
22. Heat - This product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.
The serial number of this product may be found on the bottom of the unit. You should record the number and other vital information here and retain this book as a permanent record. Serial numbers are not kept on file.
Date of Purchase |
|
| Dealer Phone No. |
|
Dealer Purchase from |
| Model No. |
| |
Dealer Address |
|
| Serial No. |
|
CAUTION: | TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY | |||
| INSERT. |
|
|
ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.
Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing or climbing on it. A falling unit can cause serious injury or even death.
3
EN