Furuno 1943C, 1933C, 1833C, 1823C, GD-1900C, 1953C manual System Configurations

SYSTEM CONFIGURATIONS

All NavNet products incorporate a “network circuit board” to integrate each NavNet product on board through an optional LAN cable (Ethernet 10BASE-T). Each NavNet product is assigned an IP address to enable transfer of images between other NavNet products. For example, video plotter pictures can be transferred to a radar and vice versa. Pictures received via the NavNet may be adjusted at the receiving end.

The number of display units which may be installed depends on the number of network sounder connected. For a system incorporating three or more products, a “hub” is required to process data.

For one network sounder: one radar and three plotters, or four plotters

For two network sounder: one radar and two plotters, or four plotters

Antenna Unit MODEL1823C

MODEL	MODEL	MODEL
1953C	1933C	1943C	MODEL
			1833C

GPS receiver

GP-310B/320B

Power Supply

Unit PSU-005

Memory card interface unit CU-200

12 VDC

Rectifier

RU-3423

Display unit

RDP-138*/139

Facsimile

Receiver

FAX-30

Echo sounder Navigator

External buzzer

PC

Echo sounder

VGA monitor Remote display Video equipment

Heading sensor

100/110/115/220/230 VAC 12 - 24 VDC** 1φ , 50/60 Hz**

*: Not available for MODEL 1953C.

**: The power for the power supply unit and display unit must be drawn from the same power source.

Network

Sounder

ETR-6/10N

ETR-30N

Other NavNet unit (GD-1900C etc.)

Figure 1 (a) NavNet system (MODEL1823C/1833C/1933C/1943C/1953C)

v