SCANNER menu
1.Open the INITIALIZE menu as described on page
2.Choose 3 SCANNER to open the SCANNER menu.
[SCANNER]
1BACK
2BLIND SECTOR 1 START 000° ANGLE 000°
3BLIND SECTOR 2 START 000° ANGLE 000°
4ANT REVOLUTION LO/HI/AUTO
5ANT SW
OFF/ON/EXT
6ANT STOPPED
STBY/TX
7M SPEC
OFF/ON
8BB TYPE
NORMAL/BB
SCANNER menu
BLIND SECTOR 1 and BLIND SECTOR 2
Set area (up to 2) where no radar pulses will be transmitted. Heading should be adjusted before setting any blind sector. For example, set the area where an interfering object at the rear of the antenna would produce a dead sector (area where no echoes appear) on the display. To enter an area, enter start bearing (relative to heading) and dead sector angle. To erase the area, enter 0 for both the START and ANGLE options. The setting range of START is 0 to 359 and ANGLE is 0 to 180 .
ANT REVOLUTION
No use.
ANT SW and ANT STOPPED
This is used for antenna maintenance by service personnel.
MSPEC
No use.
BB TYPE
Choose type of radar. Select "BB" for
