1. OPERATION

4

1.5.2 Selection of desired freq uency, fine adjustment of fr equency

Frequency may also b e entered manually by pressing the FRQ key, and then entering fr equ ency
by using the numeric k eys an d the REV/z key (for entering decimal point). The available frequency
range is 2000.0 - 24999.9 kHz.
In the frequency display mode, use the S or T key to fine tune a frequency when in the frequency
display mode, in resolution of 0.1 kHz. Whe n properly tuned, the center TUNE LED (gree n) lights.
If the upper TUNE LED (red) is lit, use the S key, and if the lower TUNE LED (red) is lit, use the
T key.
1.6 Automatic Receiving
Once you choose the facsimile station from which to receive, the system goes into standby to
await the start signal from the facsimile station. Recording starts when the start signal is recei ved.
1. Press the CH key to show the channel display.
2. Press the S or T key to choose channel desired.
Note: Alternatively, you may enter the frequenc y of the broadcasting station by pressing th e
FRQ key and entering frequency with the numeric keys and the REV/z key (for decimal point).
When the start signal is received, the message "AUTO START SEARCHING FRAME" appears
and the RCD LED (orange) flashes. Speed and IOC are automatic ally adjusted when recordi ng
starts. The RCD LED lights during recording.
Note: The TUNE LED goes off when t he RX level goes below a certa in level or the equipment is
not receiving. Even if the TUNE LED goes of f, the equipment records the fax signal as lon g as the
S/N ratio is suitable. Theref ore, this is not a sign of TUN E LED trouble or equipment malfunction.

Stopping recording

Recording stops automatically when the stop signal is received. You may also stop the recording
manually by pressing the RCD key. The RCD LED goes off when recording is stopped.
C00* JMH 3622.5
S120 I576
* Asterisk indicates automa
tic
frequency selection.