Fusion L50B PRO operating instructions Operation, Programming, NiCd Mode, Setting Charge Current

OPERATION

•When the charger is connected to the power source the charger will show the battery mode that was last used.

•If the battery TYPE button is briefly pressed, the present battery type (NiCd, NiMH, Lithium, or Pb ) will flash. While the existing battery type is flashing, every time the battery TYPE button is pressed, the following modes are shown in order:

NiCd CHARGE BATT TYPENiMH CHARGE BATT TYPE

C=3.0AC=3.0A

LiIo CHARGE	3.0A	BATT TYPE
C=3000mAh	10.8Vp

Pb CHARGE	BATT TYPE
C=3.0A 12V Pack

PROGRAMMING

NiCd Mode

BATT TYPE	CHARGE	INC		NiCd delta-peak-
	C=3.0A		DEC	volt = 0mV/cell
	ENTER			ENTER

INC DEC

NiCd CHARGE

C=3

START

BATTERY CHECK

WAIT PLEASE....

CHG 0:00 00000 NC+3.00A 5.200V

INC DEC

NiCd delta-peak- volt =

NiCd CHARGE C=3

NiCd delta-peak- volt =

Setting Charge Current

Adjust the desired charge current, which ranges from 0.1A to 6.0A with the INC & DEC buttons. Press the ENTER button to confirm the setting.

Setting Delta Peak Sensitivity

Set the Delta Peak Sensitivity from 5mV to 25mV per cell with the INC & DEC buttons and press the ENTER button to confirm the setting.

6