Fusion L50B PRO operating instructions Input Power, Output Battery Connections, 12V DC

INPUT POWER

12V DC

Connect the charger’s red alligator clip to the positive (+) terminal on the power source and the black alligator clip to the negative (-) terminal. The charger will display “Input voltage” error message if the input is below 11V or above 15V. If this happens, please recheck the input power supply to make sure correct power is present.

OUTPUT BATTERY CONNECTIONS

Two 4mm banana sockets are located on the right side of the charger. Connect the battery main power leads to these sockets with the positive

(+)lead connected to the red socket and the negative (-) lead to the black socket. You may need to purchase an adaptor lead to suit the specific connector on you battery and make this more convenient. The “No battery” error message will be displayed if trying to start charging without connecting a battery to these sockets. The “Open Circuit” error message will be displayed if a battery becomes disconnected from the charger while a function is in progress. A “Reverse Polarity” error message will be displayed if a battery is connected to the charger in reverse.

Note: In order to balance Lithium batteries during charge, please ensure that both the battery main power leads and the balancing connector from the battery pack are connected to both 4mm output banana sockets and balancing port respectively. The balancing port (JST EH type) requires a short lead (supplied) and an adaptor board to suit other battery balance connectors. Two types are supplied to suit Polyquest, Flight Power and

Thunder Power batteries (TP). Other types are available as options.

If the main battery power leads ONLY are connected to the output banana sockets, without connecting the balancing connector to the balancing port on the charger, the charger will charge or discharge the connected Lithium pack without balancing it.

5