Gaggenau AW 201-790, AW 200-790 manual Secure the hood on the wall with the four screws b and

Fig. 21

Fig. 22

Fig. 23

–Secure the hood on the wall with the four screws b (Fig. 21 and 22).

For exhaust air mode proceed as follows:

–Establish the pipe connection.

–Establish the electrical connection.

–Stainless steel chimney only (LK 010-012/022): pull the protective film off the chimney’s trims.

Note: avoid damaging the sensitive metal surfaces.

–Fit the top chimney duct unit into the base. Make sure that the fastening holes on the side are at the top.

–Put both chimney duct units onto the hood.

–Pull the top chimney duct unit up into its final position and secure it with 2 screws on the ceiling holder (Fig. 23).

Note: avoid scratches when pulling the elements apart by placing the assembly template, for example, over the edge of the bottom chimney paneling to protect it.

– Insert the grease filters.

17