| For circulating air mode use the installation set | |
| included with the ventilation ducts LK | |
| und LK | |
| charcoal filter (KF |
|
| Proceed as follows: |
|
| – Slightly loosen the screws of the retaining bracket | |
| for the chimney paneling. Hang the angle pieces | |
| onto the screws and tighten the screws. | |
| – Screw the circulating air switch module to the | |
| angle pieces (4 screws). |
|
| – Shorten the flexible air pipe accordingly. Fix the | |
| flexible air pipe with hose clamps (Fig. 24). | |
| – Establish the electrical connection. |
|
| – Stainless steel chimney only (LK | |
| pull the protective film off the chimney’s trims. | |
| Note: avoid damaging the sensitive metal surfaces. | |
| – Fit the top chimney duct unit into the base. Make | |
| sure that the fastening holes on the side are at the | |
| top. |
|
| – Put both chimney duct units onto the hood. | |
| – Pull the top chimney duct unit up into its final | |
Fig. 24 | position and secure it with 2 screws on the ceiling | |
holder (Fig. 25). |
| |
|
| |
| Note: avoid scratches when pulling the elements | |
| apart by placing the assembly template, for | |
| example, over the edge of the bottom chimney | |
| paneling to protect it. |
|
| – Insert the activated charcoal filters. |
|
| – Insert the grease filters. |
|
Fig. 25 |
|
|
18 | 9000032538 | en 06.05 EB |