19/32" | Important: before marking the securing holes, | |
| make sure that no electricity or water lines or | |
| other lines are laid at the drilling points in the wall. | |
11 13/16" | Proceed as follows: | |
| ||
12 3/16" | – From the bottom edge of the hood, mark a center | |
9 1/16" | line on the wall. | |
3" | – With the aid of the drilling template, mark the | |
positions of the screws on the wall (Fig. 19). | ||
| ||
10 5/8" | Note: this hood has been approved for installations | |
16" | ||
4" | as low as 30 ´and as high as 36 ´above the cooktop. | |
6 1/4" | – Using the drilling template, drill the 6 holes for | |
min. 30” | ||
the hood (area I of the drilling template) and the | ||
| ||
| two holes for suspending the chimney (area II of | |
| the drilling template). In the top two securing | |
| holes for the hood, fix the two hooks d with the | |
Fig. 19 | countersunk screws c. Make sure that the hooks | |
lie flatly on the wall. In certain circumstances you | ||
| may have to countersink the drill holes. Fit the | |
| included dowels a in the other drill holes. | |
| Note: at least one screw must be installed | |
| through a stud. | |
| Note: pay attention to any special accessories that | |
| you may have to fit. | |
| – Screw on the retaining bracket for the chimney | |
| paneling. | |
| – Detach the grease filters. | |
| – Hang the hood on the two hooks. Adjust the | |
| suspended element with the recessed head | |
| screw and align the hood using a spirit level | |
| (Fig. 20). | |
Fig. 20 |
| |
16 |
|