6. Assembly instructions
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a.) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including
b.)Sufficient air is needed for proper combustion end exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning (ASHRAE), and the local code authorities.
c.) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
d.)Ducted fans must always be vented to the outdoors.
e.)If this unit is to be installed over a tub or shower, it must be marked as appropriate for the appli- cation and be connected to a GFCI (Ground Fault Circuit Interrupter) - protected branch circuit.
f.) NEVER place a switch where it can be reached from a tub or shower.
WARNING:
To reduce the risk of fire, use only metal ductwork.
6.1 Technical data
Max. weight depending on version: 28.5kg
Dimensions: 353/8 ´x 22 ´
Electrical connection
Pay attention to the rating plate data.
The appliance must only be connected by an authorised specialist. The specialist is respon- sible for perfect functioning of the appliance at its installation location. He must explain the operating principle of the appliance to the user with refe- rence to the operating instructions. He must explain to the user how the appliance can be isolated from the mains whenever required.
Connection possibilities
The plug of the connecting cable is inserted into the socket that is located behind the duct cover on the wall. If this is not possible, the disconnection of all the poles of the appliance from the mains must be achieved by way of the domestic fuse, or by using an accessible disconnecting device with a contact gap of at least 3.0 mm.
13
