INSTALLATION continued
•Each thermostat controls one zone burner though a dual
•For access to the pressure test spigots, turn the main power switch and all zone power switches to the OFF position and lower the front panel on its hinge.. This is a safety precaution.. The test spigots are at the rear of the rear of the combination regulator valves..
•Connect your manometer to the first valve for test and turn the manual
NOTE : The shut off valve is under the unit.. When it is ON and in the open position, the valve position is in line with the piping.. Also, see the electrical procedure below for notes on the status indictor lights and setting the thermostats..
•Turn the main power switch and the zone power switches to the ON position..
•Set all the thermostat dials to 350˚F.. When all the burners are operating, check and record the manometer reading, which should be the same manifold pressure as that specified on the serial plate (3..5”WC for natural gas and 10..0” for propane gas).. Adjust the regulator to obtain the pressure rate specified..
•When satisfied with the reading obtained, turn the main power switch OFF.. Remove the manometer test tube and
•Repeat this operation on each combination regulator valve to correctly set it.. Then turn each thermostat, zone and main power switch OFF..
Electrical Power, Lighting & Control
WARNING : Do not work on ungrounded equipment.. It is dangerous..
•National and local electrical codes require that all devices of this type be electrically grounded.. Check to make sure the unit is grounded..
CAUTION : Make sure the electrical connections enclosed by the panels are in good order and undamaged before closing and securing the front panels..
NOTE : This griddle is equipped with a
•To check the unit lighting, turn the main power switch of the unit to the ON position.. The green light of the power switch and the green indictor of the gas pilot of each section of the griddle should illuminate..
CAUTION : If after two minutes the pilot ignition fails, turn the main power switch OFF.. Wait five minutes and switch the main power ON again..
•When the green indicator for each zone is illuminated, turn the zone power switch for each zone ON.. The thermostats can now be set to the desired temperature..
•The amber light burner indicator cycles with the operation of the thermostat..
Ventilation
For efficient operation this unit requires a minimum ventilation air supply of 50frm.. The ideal method of ventilation is a
Gas burners and pilot devices need a sufficient air supply to operate efficiently, so do not place large objects anywhere near them to restrict or in any way limit the air flow..
In most operations, the chain griddle will be used in conjunction with other kitchen equipment.. The need for the ingress of air to the kitchen area must be sufficient to compensate for the air the ventilation system abstracts.. Unless the air flow is sufficient a subnormal, and probable negative, atmospheric pressure will result, which will adversely affect the operation of the equipment and make work in the kitchen area unpleasant..
Start-Up
When the chain griddle is used for the first time, the griddle top requires seasoning.. To season a griddle surface, follow this procedure..
1.Wash the griddle surface with a hot, mild detergent or soap solution, then rinse and dry thoroughly..
2.Set the thermostat to 175˚F for 30 minutes, then apply a film of cooking oil to the cooking surface and wipe away the excess..
3.After (5) five minutes, wipe the griddle plate clean..
Part #GCGTRAINING06 (03/03/08) | Page |
