Installation

Mounting the Transducer

DO NOT mount the transducer behind strakes, struts, fittings, water intake or discharge ports, or anything that creates air bubbles or causes the water to become turbulent. It is important that the transducer be in calm, non-turbulent water for optimal performance.

Proper transducer installation is key to getting the best performance from your new unit. If the transducer lead is too short, extension cables are available from you GARMIN dealer. DO NOT cut the transducer lead or any part of the transducer cable, as this will void your warranty. The cable cannot be spliced and connected to any existing (GARMIN or non- GARMIN) transducer cables.

Following are some tips and basic installation instructions for the optional dual frequency transducer and speed sensor. Detailed installation instructions are provided in the transducer kits.

Transom Mount Installation

Dual Frequency Transom Mount Transducer (with depth/temp).

Apply marine sealant to all

Mount the transducer cable cover

screw threads to prevent water

well above the waterline.

from seeping into the transom.

 

Transducer should extend 1/8" below fiberglass hull or 3/8" below aluminum hull

OK

Make sure that the transducer is below water level when the boat is on plane at high speed

Do not mount transducer directly in the path of the prop. The transducer can cause cavitation that may degrade the boat's performance and damage the prop.

2

Mount the transducer parallel with the bottom.