SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
6.To Replace a Grill Controller
Disconnect the appliance from the electricity supply.
a)Remove the hotplate as detailed in Section 1.
b)Remove the control panel as detailed in Section 2.
c)Disconnect the controller wiring. Undo the fixings that secure the device to the mounting plate.
d)Fit the replacement and
7.To Remove an Oven Cut-Off Thermostat
Disconnect the appliance from the electricity supply.
a)Pull the unit forward to gain access to the cover box. Undo the cover screws and lift clear.
b)The control is located on the earth plate beside the oven element connections.
c)Disconnect the thermostat wiring. Undo the fixings that secure the thermostat to the earth plate and remove.
d)Fit replacement control and
e)Fit the replacement electrode to the burner bezel. Ensure that the spring and clip are properly located.
f)Replace in reverse order and check correct burner ignition.
12.To Remove a Hotplate Burner
a)Remove the pan supports, hotplate accessories and burner heads.
b)Remove the hotplate as detailed in Section 1.
c)Undo the compression fitting which connects the burner body to the gas pipe.
d)Remove the nut that secures the burner body to the support channel.
e)Remove the fixings that secure the support channel to the chassis. Lift the channel clear of the appliance.
f)Remove the burner body from the appliance.
g)Replace in reverse order. Check the appliance is gas sound and that the burner operates satisfactorily.
8.To Remove a Hotplate Tap
a)Remove the hotplate as detailed in Section 1.
b)Remove the control panel as detailed in Section 2.
c)Unplug the FSD lead from the rear of the tap. Undo compression fitting at the rear of the tap. Remove the fixings that secure the tap to the gas rail. Disconnect the ignition switch wiring.
d)Remove the tap. Remove and discard the gasket seal. Fit new gasket seal to replacement tap.
e)
9.To Change an Ignition Switch
Change the gas tap as detailed in Section 8.
10.To Remove a Hotplate Burner Injector
a)Remove the hotplate as detailed in Section 1.
b)Remove the injector directly from the burner body.
c)Fit the appropriate injector.
d)
11.To Remove a Hotplate Burner Spark Electrode
a)Remove the pan supports, hotplate accessories and burner heads.
b)Undo the bezel venturi and remove the bezel from the hotplate. The spark ignition wire will be pulled through the electrode clearance hole.
c)Disconnect the spark electrode from the ignition wire.
Note: Take care to prevent the ignition wire from falling back through the clearance hole.
d)Undo the spark electrode from the bezel by removing the spring clip and spring.
13.To Remove the Oven Door
a)Open the oven door.
b)Support the door and remove the two screws which secure the upper hinge to the front frame of the unit.
c)Remove the door from the lower hinge by lifting slightly and moving it outward.
d)
14.To Remove the Grill Door
a)Remove the pan supports, hotplate accessories and burner heads.
b)Remove the hotplate as detailed in Section 1.
c)Remove the control panel as detailed in Section 2
d)Remove LH side panel a detailed in Section 3.
e)Remove the plinth (3 screws).
f)Remove the central vertical cover situated between the ovens. (5 screws).
g)Remove the 2 countersunk screws (1 per side) which secure the hinge arms to the front of the grill chamber.
Note: The door hinge arms are spring tensioned. Carefully remove the grill door and retain the gaskets.
h)
29