Garmin 210 GEO T DL user manual Servicing - Warning, To Remove the Oven Outer Door Panel

SERVICING - WARNING

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

15. To Remove the Oven Outer Door Panel 18. To Adjust the Oven Door Catch Keeper

a)Open the oven door.

b)Remove two screws ‘A’ and two screws ‘B’ from the door.

c)Remove the outer door panel.

d)Undo the nuts that secure the handle to the door panel. Fit the handle to the replacement door panel.

e)Fit the replacement panel to the oven inner door making sure that the door insulation is correctly located.

f)Re-assemble in reverse order.

16.To Remove the Door Latch

a)Remove the oven outer door panel as detailed in Section 15.

b)Remove the fixings that secure the latch assembly to the inner door panel.

c)Fit the replacement catch and re-assemble in reverse order.

d)Check correct operation of door.

17.To Remove the Oven Door Seal

a)Open oven door. The seal is held in place by small hooks on the rear face. At the corner pull seal diagonally away from the door centre until that hook is released.

b)Proceed to the next hook and release it in a similar way, and so on. Use force if the hooks are stiff, as the old seal will be discarded.

c)When fitting new seal, position the seal join at the bottom. Hook the new seal in one of the corner holes of the door, and proceed round the door snapping in each hook in turn.

a)Open the oven door and slacken the locknut at the keeper base.

b)Adjust the keeper inward or outward as required, until the desired door operation is obtained.

c)Re-tighten the locknut.

19.To Remove the Hotplate Spark Generator

Disconnect the appliance from the electricity supply.

a)Pull the unit forward to access the cover boxes at the appliance rear. Remove the fixings that secure the cover and lift it clear.

b)Undo the terminal connections noting their positions.

c)Undo the fixings that secure the spark generator and remove the device.

20.To Remove the Hotplate Electrode Leads

Disconnect from the electricity supply.

Pull the unit forward to access the rear of the appliance.

a)Remove the pan supports, hotplate accessories and burner heads.

b)Remove the hotplate as detailed in Section 1.

c)Remove the cover box and disconnect all HT leads at the generator.

d)Remove the lower back panel and disconnect the lead at the electrode.

e)Pull the sleeved bundle of HT leads up through the rear upright.

f)Pull the appropriate lead from the sleeve and push in the replacement.

g)Replace the leads in the rear upright.

h)Re-connect the leads at the generator and oven electrode.

j)Re-assemble in reverse order and check ignition.

21.To Remove Oven Inner Back

a)Open the oven door. For the LH oven unscrew the 2 thermostat phial fixing screws. Remove the fixings that secure the inner back to the oven rear.

b)Lift the removable panel away.

c)Re-assemble in reverse order. Ensure that the retaining fixings are fully tightened.

22.To Replace an Oven Fan

Disconnect the appliance from the electricity supply.

a)Pull the unit forward to access the cover boxes at the rear of the appliance. Remove the fixings that secure the cover and lift it clear.

b)Remove the fan wiring, noting the connection positions.

c)Remove the inner back as detailed in Section 21.

d)Hold the fan blades and undo the centre nut (LH thread), brass washers, fan blade and circlip.

e)Undo the fixings that retain the fan and remove it from the cavity rear.

30