SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
f)Fit the replacement and
23.To Remove an Oven fan Element
Disconnect the appliance from the electricity supply.
a)Remove oven inner back (see 21).
b)Remove 2 screws from the top of the element and 1 from the bottom of the element in side the oven.
c)Lift element out carefully, disconnect the terminals connected to the element noting their positions. If it is not possible to disconnect the leads in this way, pull cooker forward to gain access to the rear, remove screws securing the electric cover to the back sheet and remove cover and disconnect the terminals from the rear.
d)Fit new element, and reassemble in reverse order.
e)Check that the oven operates correctly.
24.To Remove the LH Oven Bottom and Top Elements
Disconnect the appliance from the electricity supply.
Bottom Element
a)Pull the unit forward to access the cover boxes at the rear of the unit. Remove the fixings that secure the cover and lift it clear.
b)Undo the terminal connections, noting their positions.
c)Remove the fixings that secure the bottom element cover.
d)Undo the terminal connections, noting their positions.
e)Remove the lower element support fixings.
f)Remove the element bracket fixings and withdraw element.
g)Replace the element and
Top Element
a)Open the LH oven door and undo the fixings that secure the heat shield.
b)Remove the top element bracket fixings and withdraw element.
c)Replace the element and
25.To Remove a Grill Element
Disconnect the appliance from the electricity supply.
a)Pull the grill carriage forward and lift the grill pan away from the carriage. Lift the grill carriage so that the front roller is free of the side arm. Slide the carriage forward on the rear roller until you can lift it away from the side arm.
b)From inside grill compartment remove enamelled front shield from grill roof, 2 screws and washers. Remove 2 screws and washers securing the grill element front support.
c)Remove the screws from the grill elements. Lift elements out carefully, disconnect the leads from the element terminals noting their position.
d)If it is not possible to disconnect the leads in this way, turn off the gas supply. Remove the drawer
– lower the front roller. Pull the cooker forward and disconnect the gas hose. Pull the cooker far enough forward to gain access to the rear.
e)Remove the fixings that secure the rear cover and lift it clear. Disconnect the terminals from the rear.
f)Fit new elements, reassemble in reverse order. Check operation of grill.
26.To Adjust the Main Oven Door Angle
a)The door bottom hinge can be adjusted to alter the angle of the door.
b)Loosen the bottom hinge fixing screws and use the notch and a flat bladed screwdriver to move the position of the hinge to set the hinge position.
c)Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
31
