GarrettCom ES42 manual Make sure that an AC power cord is properly attached to each Magnum

ES42 Series Edge Switches Installation and User Guide (05/05)

3.If the fiber port does not link up while connecting to other device, do a quick Loop test to test the fiber transceiver is functional or not. Use a short patch cable of fiber and connect one end of cable to transmit and other end of receive to the fiber port transceiver. If the Link Led turns solid green, then the fiber port is functional and working.

4.Make sure that an AC power cord is properly attached to each Magnum

ES42-Series unit. Be certain that the AC power cord is plugged into a functioning and appropriate electrical outlet. Use the PWR LEDs to verify each unit is receiving power.

5.If the problem is isolated to a network device other than the Magnum ES42 Series 10/100 Mb/s switch product, it is recommended that

the problem device is replaced with a known good device. Verify whether or not the problem is corrected. If not, go to Step 6 below. If the problem is

www . GarrettCom. com

64