ES42 Series Edge Switches | Installation and User Guide (05/05) |
3.7ES42H and P Series, DC-powered, 12VDC, 24VDC and -48VDC Installation This section describes the proper connection
of the -48VDC leads (or 24VDC, 12VDC leads) to the DC power terminal block on the Magnum ES42H Edge Switch (as shown in the Figure). The DC terminal block on the Magnum ES42H is located on the left side of the unit and is equipped with three (3) screw-down lead posts. The power terminals are identified as positive (+) and negative (-), and they are floating inside the unit so that either of the terminals may be grounded by the user if desired. The chassis is “earth” or ground (GND). The connection procedure is straightforward. Simply insert
www . GarrettCom. com
