FIGURE 1 - HyperTerminal screen showing the serial settings................................................................. 24
FIGURE 2 - Prompt indicating the switch model number as well as mode of operation – note the
commands to switch between the levels is not shown here.............................................................. 25
FIGURE 3 - Setting IP address on the switch......................................................................................... 26
FIGURE 4 - Rebooting the switch.......................................................................................................... 27
FIGURE 5 - Viewing the basic setup parameters. You can use ‘show setup’ or ‘show sysconfig’ to
view setup parameters ................................................................................................................27
FIGURE 6 - Switching users and privilege levels. Note the prompt changes with the new privilege
level. .........................................................................................................................................28
FIGURE 7 - Adding a user with Manager level privilege .......................................................................29
FIGURE 8 - Deleting a user................................................................................................................. 29
FIGURE 9 - Changing the password for a specific user........................................................................... 29
FIGURE 10 - Changing the privilege levels for a user............................................................................. 30
FIGURE 11 – Creating user access privileges........................................................................................... 30
FIGURE 12 - Help command.............................................................................................................. 31
FIGURE 13 - Help for a specific command...........................................................................................31
FIGURE 14 - Options for the ‘show’ command...................................................................................... 32
FIGURE 15 - Listing commands available (at the operator level) ...........................................................32
FIGURE 16 - Listing commands starting with a specific character.......................................................... 32
FIGURE 17 - Listing commands options – note the command was not completed and the TAB
key completed the command. ......................................................................................................33
FIGURE 18 – logout command.............................................................................................................. 33
FIGURE 19 - Checking the IP settings..................................................................................................36
FIGURE 20 - Changing the boot mode of the switch ..............................................................................38
FIGURE 21 - Changing telnet access – note in this case, the enable command was repeated without
any effect to the switch................................................................................................................38
FIGURE 22 - Reviewing the console parameters – note telnet is enabled .................................................39
FIGURE 23 - Example of a telnet session.............................................................................................39
FIGURE 24 – managing and viewing multiple telnet sessions.................................................................. 40
xi