MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
Variable or Attribute Default Value
STP capabilities Disabled
reconfiguring general operation priority 32768
Bridge maximum age 20 seconds
Hello time 2 seconds
Forward delay 15 seconds
Reconfiguring per-port STP path cost 0
Priority 32768
Mode Normal
Monitoring of STP Not Available
Root Port Not set
Figure 74 – STP default values – refer to next section “Using STP” for more detailed explanation on
the variables
1. By default, STP is disabled. To use STP, it has to be manually enabled.
2. If you are using tagged VLANs, at least one untagged VLAN must be
available for the BPDU’s to propagate through the network to update STP
status.
Using STP The commands used for configuring STP are listed below.
Syntax
show stp <config|ports > - regardless of whether STP is enabled or disabled (default) this
command lists the switch’s full STP configuration, including general settings and port settings
Magnum6K25# show stp config
STP CONFIGURATION
-----------------
Spanning Tree Enabled(Global) : NO
Spanning Tree Enabled(Ports) : YES, 9,10,11,12,13,14,15,16
Protocol : Normal STP
Bridge ID : 80:00:00:20:06:25:ed:80
Bridge Priority : 32768
Bridge Forward Delay : 15
124