MAGNUM 6K SWITCHES, MNS-6K USER GUIDE
connected to other switches. From the state column, it indicates that port 7 is in a standby state as
that port is discarding all traffic.
More CLI commands associated with RSTP in the RSTP configuration mode are:
Syntax forceversion <stp|rstp> - set the STP or RSTP compatibility mode
Syntax show-forceversion - the current force version
Syntax show-timers – show the values of the timers set for RSTP
Syntax priority [port=<number|list|range>] value=<0-255 | 0-65535> - specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports and their value is 0-
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
Syntax cost port=<number|list|range> value=<0-65535> - cost is specific to a port and the port(s)
have to be specified
Syntax port port=<number|list|range> status=<enable|disable> - specific ports may not need to
participate in STP process. These ports typically would be end-stations. If you are not sure – let MNS-6K
software make the decisions
Syntax timers forward-delay=<4-30> hello=<1-10> age=<6-40> - change the STP Forward delay,
Hello timer and Aging timer values
Priority: specifies the switch (bridge) priority value. This value is used along with the
switch MAC address to determine which switch in the network is the root device. Lower
values mean higher priority. Value ranges from 0 to 65535. Default value is 32768
Cost: A path cost is assigned to individual ports for the switch to determine which ports
are the forwarding points. A higher cost means the link is “more expensive” to use and
falls in the passive mode compared to the link with a lower cost. Value ranges from 0 to
65535. Default value is 32768
Status: Enables or disables a port from participating in STP discovery. It’s best to only
allow trunk ports to participate in STP. End stations need not participate in STP process.
Forward-Delay: indicates the time duration the switch will wait from listening to learning
states and from learning to forwarding states. The value ranges from 4 to 30 seconds.
Default value is 15
Hello: When the switch is the root device, this is the time between messages being
transmitted. The value is from 1 to 10 seconds. Default value is 2 seconds
142