Follow the instructions in “Opening the server case” on page 30.
Record the BIOS settings on your printout, then close the utility.
Print the appendix for “BIOS Settings” on page 83.

Replacing the CMOS battery

If the server clock does not keep time or the settings in the BIOS Setup utility are not saved when you turn off the server, replace the CMOS battery with an equivalent battery.

Warning Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of or recycle used batteries by taking them to a hazardous waste facility. Follow all local regulations for correct battery disposal.

To replace the battery:

1

2 Open the BIOS Setup utility. For instructions, see “Opening the BIOS Setup utility” on page 58.

3

4 Turn off your server, then follow the instructions in “Preventing static electricity discharge” on page 29.

5

6 Locate the old battery on the system board and note its orientation. You will need to install the new battery the same way.

CMOS battery

7 Push the battery retention clip away from the battery until the battery pops up, then remove the old battery. You can use a screwdriver to help lift the battery.

8 Make sure that the positive (+) side of the new battery is facing up, then press the new battery into the socket until it snaps into place.

www.gateway.com

49