BIOS

The settings in the BIOS Setup utility are not retained

Replace the CMOS battery. For instructions, see “Replacing the CMOS battery” on page 49.

CD drive

Your server does not recognize a CD or the CD drive

Restart your server, then open the BIOS Setup utility by pressing and holding F2 while your server restarts. Make sure that the IDE controllers are enabled. For more information, see “Using the BIOS Setup Utility” on page 57.

Reinstall the device driver. For instructions, see “Using your System Companion CD” on page 20.

Turn off your server, then make sure the drive cables are connected correctly. For instructions, see “Installing a CD or diskette drive” on page 33.

Your CD drive tray does not open

Press a straightened paper clip wire into the CD drive’s manual eject hole. The drive tray opens.

If this problem happens frequently while the server is turned on, the drive may be defective.

Diskette drive

The diskette drive is not recognized

Restart your server.

Turn off your server, then make sure that the drive cables are connected correctly. For instructions, see “Installing a CD or diskette drive” on page 33.

The diskette drive LED is lit continuously

Remove the diskette from the drive. If the light stays on, try restarting your server.

Turn off your server, then remove the combination drive and push it in again to make sure the drive is seated correctly. For instructions, see “Installing a CD or diskette drive” on page 33.

72

www.gateway.com