Chapter 2: Unit Installation
Ethernet Status - These LEDs correspond to the status of the Ethernet connection. See Frequently Asked Questions on page 80 for more information.
USB Recovery - This port can be used to perform a firmware recovery and configuration reset. See Firmware Recovery and Configuration Reset on page 78 for more information.
Warning! The USB Recovery port provides a limited amount of current which is sufficient only to power a USB flash drive. Do not connect any other type of device to this port. The USB flash drive should be fully USB 2.0 compliant.
T1/E1 Port(s) - These ports are used for connecting T1 or E1 cables. See RJ45 T1/E1 Port Connector on page 86 for more information.
T1/E1 Status - These LEDs correspond to the status of the T1/E1 ports. See Frequently Asked Questions on page 80 for more infor mation.
Reset Switch (G400/G800 only) - This recessed switch is used to restart the Gateway Series appliance or reset its GUI password. See Frequently Asked Questions on page 80 for more information.
Digium, Inc. | Page 22 |