Chapter 2: Unit Installation
Connecting Ports
A description of each of the front panel connectors on a Gateway Series appliance is available in the section titled Front Panel Identification on page 19. Please refer to that section to determine what should be connected to each connector.
Caution
This unit must be connected to the Telecommunications Network in your country using an approved line cord, e.g.: for Australia use only line cords complying with AS/CA S008:2010.
Caution
Connect only equipment approved for use in your specific country to the telecommunications network voltage circuit ports.
Connections to a Gateway Series appliance should be made in the following order.
1.Gigabit Ethernet Port(s)
Note: (G400/G800 only) Install a ferrite to the Ethernet cable that connects to each Ethernet port to ensure compliance with the EMC standards. An example of a suitable ferrite is part number
2.T1/E1 Port(s)
Note: Use only shielded cables to ensure compliance with the International EMC standards.
3.Power Cord
Digium, Inc. | Page 32 |