GBC 3064WF

Operation Manual

APPLICATIONS

MOUNT

ADHESIVE

TRAILOR BOARD

LEADER BOARD

 

 

BOARDS

Figure 30

IMAGE

RELEASE LINER

PRE-COATED BOARD

Figure 31

MOUNT

ADHESIVE

RELEASELINERFROM PSA FILM

OUTPUT

IMAGE

ROLLTO ROLLOPTION

KRAFT

PAPER

OPTION

Tips for Pre Coating Boards

1.Load the laminator as illustrated in (Fig. 30). Remove chill idler.

2.The width of the roll should not exceed the width of the board by more than 1/2 in. (1.3 cm).

3.Use a leader board to set the main roller and pull roller pressure prior to webbing.

4.Use a leader board to start the run and a trailer board to finish the run.

5.Using the pull rollers will allow you to leave gaps between boards.

6.If not using the pull rollers, have the boards nearby to butt end to end during feeding.

Tips for Mounting Pre Coated Boards

1.Use a leader board to set the main roller pressure prior to mounting the image.

2.Ensure the chill idler is removed and the rear slitter is to one side.

3.Do not stop once you have started the mounting process through the machine. (Fig. 31)

Note: This application can also be performed from the rear operating position. Reference Fig. 34 for Illustration.

Tips for Single Sided lamination

1.Load the laminator as illustrated in Fig. 32.

2.Use kraft paper for one-sided lamination When ever the items to be laminated are narrower than the film you are using.

3.If not using kraft paper, use a scrap piece to finish the run or you will have adhesive on your rollers.

4.For high volume runs, use Kraft paper and the lower rear rewind for roll to roll operation.

5.Running the web over the chill idler may improve the Flatness of the output.

6.A little heat 125oF (52oC) may help eliminate silvering effects associated with PSA films.

Figure 32

© 2005 General Binding Corporation

Page 21

Page 21
Image 21
GBC 3064WF operation manual Applications, Tips for Pre Coating Boards, Tips for Mounting Pre Coated Boards