GBC 3064WF operation manual Tension, Service Agreement

GBC 3064WF		Operation Manual
TROUBLE SHOOTING GUIDE
SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
The control panel display does not	Laminator not connected to electrical	Insert attachment plug into
illuminate when POWER ON/OFF	supply	receptacle
is in the ON, marked “I”, position.	Blown out fuse.	Check fuses.
Heat rollers do not turn when	Feed table not properly installed.	Tilt feed table and properly replace
POWER ON/OFF is in the ON,		it.
marked “I”, position.
Press the “RUN” ( ) button and the	E-Stop button activated	Pull out on the E-STOP turn
motor does not turn.		clockwise.
Heat rollers only turn if I use the	Photo eye is blocked.	Disengage the footswitch mode.
“Footswitch”.		Clear nip area.
Laminated items exhibit curling.	Tension between the top and bottom	Adjust tension per section FILM
	film. Roll is unequal.	TENSION.
	Tension on top or bottom roll of film	Adjust tension per section FILM
	is too film is too loose.	TENSION.
	Bottom film roll may be improperly	Make sure bottom roll of film is
	loaded.	around idler bar and that is the
		normal operation position.
Adhesive deposited on heat rollers.	Top and bottom film webs not	Release heat and pull roller pressure,
	aligned	align the rolls of film.
	Laminate improperly loaded.	Adhesive (matte) side of laminate
		film may be against the heat rollers.
		Unweb and reload the film properly.
	Speed setting too fast for type of	Lower speed setting.
	material being laminated
	Insufficient heat	Wait for “READY” indicator to
		appear in the control panel display.
	Laminate improperly loaded	Adhesive side of film must be facing
		away from the heat rollers.
	Heat rollers require cleaning.	Bottom roll of film not threaded
		behind the idle bar.
	Laminated item unsuitable for	Clean heat rollers per procedure in
	adhesion.	section CARING FOR THE GBC
		3064 WF LAMINATOR. Item may
		be dirty or may have non porous
		surface that is extremely difficult to
		laminate.
SERVICE AGREEMENT

GBC’s Equipment Maintenance Agreement will insure the quality performance and long life built into your laminator.

A service charge for travel time, labor and parts may be incurred for each out of warranty service call. GBC’s Equipment Maintenance Agreement decreases these expenses and protects your valuable investment. GBC offers several types of agreements to suit your needs and budget. To contact

GBC write to:
GBC NATIONAL SERVICE	IN CANADA:	GBC NATIONAL SERVICE
ONE GBC PLAZA		49 RAILSIDE ROAD
NORTHBROOK, IL 60062 U.S.A.		DON MILLS, ONTARIO
		M3A 1B3
General Binding Corporation
One GBC Plaza
Northbrook, IL 60062-4195
®

© 2005 General Binding Corporation Page 27