GBC 80-99 1. Setup:, 2. Procedure:, Cold Overlamination (Using a Sled)

Orca 80-99 Operation and Maintenance Manual Operations

C. Raise Main Roll (Hot).

D. Reverse Motor.

E. 2nd Pass: Set Nip Height and tack leading edge.

Run through as liner is being pulled off.

Cold Overlamination (Using a Sled)

1. Setup:

A. Refer to charts 2-9 and 2-9B

B.Set main roll shims to 3/16"

2. Procedure:

A.Use a starter board to get the film started and feeding without wrinkles.

B.Lay image on the sled and place it up against the leader board.

C.Feed image through the nip following the leader board into the nip. Maintain paper tension on the image until it is through the nip.

D.Cut around the image with a sharp knife to remove it from the leader board.

© GBC Films Group June 2000 Page 5 - 9